Skip to content
Open in Editor

Necromancy Araxxor: nopenope

Note: a Table of Contents can be found in the pinned messages for this channel.

​

Introduction

This is an advanced guide which assumes a strong underlying knowledge of all mechanics and information presented in #araxxor-basic. This guide will focus on successfully executing a P3 skip for the nopenope feat which may be found in #Feats Roles.

​

Presets and Relics

Preset Suggestions
⬥ Necromancy preset necromancy

Preset Notes

​

⬥ It is recommended to have the NopeNopeNope nopenopenope perk from Player Owned Farms active.

​

⬥ Upkeep the kalgscroll buff from your familiar.

‎ ‎ ‎ ‎• Can do so by setting the autofire rate to 30.

​

⬥ Araxxor takes a few seconds to clear vulns on phase 1-3, making vuln bombs vulnbomb usable on all phases.

​

⬥ The Ranged variant of Araxxor only decreases the anti-poison timer rather than overload timer.

‎ ‎ ‎ ‎• Going into an instance and equipping any melee weapon (e.g., nymorablade) before Araxxor spawns forces a Ranged spawn.

​

Top Path (Take this path for P3 skip)

⬥ Phase 1

‎ ‎ ‎ ‎• This phase is timegated so it can be used to set yourself up for phase 2 while you deal damage.

‎ ‎ ‎ ‎• You will need to improvise a lot of your set up based on stacks gained and damage done.

‎ ‎ ‎ ‎• It is very important to not use fingerofdeath + volleyofsouls in Phase 1 as you will not have the stacks for the skip.

‎ ‎ ‎ ‎ ‎ ‎ ‎ ‎⬩ Due to this you have a lack of damage aside from the start + spectralscythe which is also good for residualsoul stacks.

‎ ‎ ‎ ‎• Can delay invokelordofbones → conjurearmy → lifetransfer until about 0:20.

‎ ‎ ‎ ‎• Try to be near or at 100% adrenaline at the end of P1.

​

Set up:

invokedeath → omniguard spec → necroauto → deathguard90 eofspec → anti → touchofdeath → soulsap → build 12 necrosis stacks + 5 residualsoul stacks

​

At 12 necrosis stacks + 5 residualsoul stacks, conjurearmy → filler → commandghost

​

⬥ Phase 2 (To skip P3)

‎ ‎ ‎ ‎• The ideal method is to bring Araxxor directly into phase 3, through the usage of a Powerburst of Acceleration accel. It can be used any time after 0:57.

‎ ‎ ‎ ‎• kalgscroll + surge + dive → surge + accel + invokedeath → surge + dive → dive + surge → dive → (tc) + deathskulls → fingerofdeath → volleyofsouls → fingerofdeath if needed

‎ ‎ ‎ ‎ ‎ ‎ ‎ ‎⬩ Trigger player movement on every tick along with your mobility abilities.

‎ ‎ ‎ ‎ ‎ ‎ ‎ ‎⬩ Clicking on an enlarged minimap may be helpful in facilitating movement and bd placements across the path.

‎‎ ‎ ‎ ‎• Alternatively, you may splitsoul + invokedeath before running up and back the path during P2. Then while having 12 necrosis stacks + 5 residualsoul stacks use volleyofsouls and then deathguard90 eofspec

​

Note: The first surge bd could be executed when web burn reads 99%, if wanting to save time.

​

Phase 4

⬥ kalgscroll + dummy + lifetransfer (if needed) + adrenrenewal + (tc) touchofdeath → livingdeath → touchofdeath → necroauto → necroauto → invokedeath → commandskeleton → target araxxi + deathskulls + vulnbomb → fingerofdeath + omniguard spec → deathspark → filler or deathguard90 eofspec and improvise as needed.

​

Note: If you get a relentless5 proc, you could probably skip a few necroauto

​

Example Kills

Successful P3 Skip
⬥ 1:40.8 nopenope with Necromancy

Content Provided by: @Unknown user

Formatting Maintained by: @Unknown user